Replacing a defective SIGA-CT1 Module on a QS1

[pyrosucks]

If mapping is enabled, just replace it and panel will reassign serial number automatically.

[packerfan]

When I looked at the options from the keypad I seen the option for mapping. I believe it said no. Can you describe mapping? Can I enable mapping from the keypad to replace this device then turn it off on the device is replaced?

thanks again

[pyrosucks]

Normally it stays on all the time. You should not have to do anything. Just put the new device in

[pyrosucks]

Alternatively, i believe you can modify a device s/n via the keypad

[packerfan]

I have a customer that has a defective SIGA- CT1 module (it got wet) on their QS1 panel. I have the level 4 pass code for the panel

Can I replace the defective module with a new one and simply change the serial number through the keypad or do I need to have the software and download the panel?

Thanks for you help