EST3 to BMS Communications Bridge FSB-PC

[hijazih]

Hi all,

Has anyone used FSB-PC before?? please advise how to import the addresses to the FSP-PC configuration software.

[junjun]

give me the details or the points to be monitored by BMS i will configure it for you..

[hijazih]

I still didnt run the fire alarm panel. I'm still in the installation phase. If u can tell me how to deal with such device it would be good.

what details you want, i can get some data from an existing project so that to get familiar with this device.

thank you

[junjun]

You can give me which device logical address of fire alarm to be monitored and what kind of communication to be use between fsb-pc and bms.

[junjun]

Its either one of this protocols:
Bacnet-ethernet
Bacnet-ip
Modbus
Lonworx
Etc...

[hijazih]

Can i use 2 protocols simultaneously, i mean i want to interface with two systems using 1 FSB-PC, but each system using separate protocol.

[junjun]

No, cause every protocol have different configuration table.

[hijazih]

i've attached a sample of the logical addresses

[hijazih]

Do any protocol sends ASCII data ???

[junjun]

here's are one sample for configuring Bacnet IP protocol.