program a cr to activate during reset phase
Posted: Thu Dec 24, 2015 12:13 pm
Anyone here have a clue how to use the reset pseudopoint to toggle a relay?
It's in the help file (monitor point) but doesn't give an example.
It's also not available in the correlation screen. Thanks
nevermind, there's a tab you click to setup the input event for the output response.
It actually works OK for a 4-wire device that takes a momentary reset command.
It's in the help file (monitor point) but doesn't give an example.
It's also not available in the correlation screen. Thanks
nevermind, there's a tab you click to setup the input event for the output response.
It actually works OK for a 4-wire device that takes a momentary reset command.