Page 1 of 1
Re: Replacing a defective SIGA-CT1 Module on a QS1
Posted: Wed Aug 20, 2014 5:47 am
by pyrosucks
If mapping is enabled, just replace it and panel will reassign serial number automatically.
Re: Replacing a defective SIGA-CT1 Module on a QS1
Posted: Wed Aug 20, 2014 8:23 pm
by packerfan
When I looked at the options from the keypad I seen the option for mapping. I believe it said no. Can you describe mapping? Can I enable mapping from the keypad to replace this device then turn it off on the device is replaced?
thanks again
Re: Replacing a defective SIGA-CT1 Module on a QS1
Posted: Thu Aug 21, 2014 5:21 am
by pyrosucks
Normally it stays on all the time. You should not have to do anything. Just put the new device in
Re: Replacing a defective SIGA-CT1 Module on a QS1
Posted: Thu Aug 21, 2014 5:22 am
by pyrosucks
Alternatively, i believe you can modify a device s/n via the keypad
Replacing a defective SIGA-CT1 Module on a QS1
Posted: Tue Aug 19, 2014 7:08 pm
by packerfan
I have a customer that has a defective SIGA- CT1 module (it got wet) on their QS1 panel. I have the level 4 pass code for the panel
Can I replace the defective module with a new one and simply change the serial number through the keypad or do I need to have the software and download the panel?
Thanks for you help