Honeywell Netaxs-4 ingress configuration
Posted: Tue Nov 01, 2016 3:15 pm
I am trying to configure what seems to be a pretty simple setup:
Door is locked 24/7
Office hours are 8:00am to 6:00pm
If door is scanned by "admin" during non-office hours, then the "admin" is allowed inside and the door locks behind him.
If door is scanned by "admin during office hours, then the door stays unlocked, allowing free in/egress, until either: 1) "admin" leaves and rescans the card, or 2) time goes past office hours (6:00pm) and the door then locks automatically without further input from user.
I feel it better to not try and explain what has been tried so far, considering it hasn't worked.
I would appreciate any advice that could be given. The panel is a Honeywell NetAXS-4 running software v2.2.21.
Thank you for any consideration or input.
Door is locked 24/7
Office hours are 8:00am to 6:00pm
If door is scanned by "admin" during non-office hours, then the "admin" is allowed inside and the door locks behind him.
If door is scanned by "admin during office hours, then the door stays unlocked, allowing free in/egress, until either: 1) "admin" leaves and rescans the card, or 2) time goes past office hours (6:00pm) and the door then locks automatically without further input from user.
I feel it better to not try and explain what has been tried so far, considering it hasn't worked.
I would appreciate any advice that could be given. The panel is a Honeywell NetAXS-4 running software v2.2.21.
Thank you for any consideration or input.