TheAlarmTech.com

From the pseudo zone info you provided below, the first thing I believe you need to deal with is the unprogrammed device datacard 1. by resolving this issue, the other issues may resolve themselves. On the CPU´s display shows these troubles: LOCAL TRBL ACT CARD 4 DATABASE OUT OF SYNC W CPU LOCAL TRB...

You have 145 devices communicating and only 144 serial numbers found...... #1-) Sometimes a detector doesn't want to map because the detector isn't seated well. IE- If when someone is installing a detector base and they over-tighten the base into the 4 inch box, it kind of "cocks" the base...

Another way to stop this from Happening is by using Priorities.
SW 'SW13*' : ON 'LED37*',
OFF -HIGH 'ALOFT_SPEAKERS_STROBES',
OFF -HIGH 'SOUNDER_BASES'

-- Normally, When outputs are activated in the Est program, its done by -Low Priority

0022 Ext Database Incompatibility: CPU Changes to the active state when a different database in one or more network nodes. -- Did you Compile, Convert and Load only a certain CPU and not All on Network? -- Did you Forget to Load a CPU? --- TIP --- Do you know you do not have to Load every SDDC/AADC ...

BE careful when installing n a VM. Most VM configurations are going to have some sort of SAN/NAS on the back-end to hold the various VM's. Honey suggested getting a Hardware License key as the RAID setup may cause issues with licensing. The encryption software writes files to your hard drive as part...

You know what will fix your problem......
Re-initialize the SSDC Loop in question.
Let the SSDC card Rebuild a Map of What is out in the "field"
The reconcile map

I used to be a "Site Tech" for an Est3 network that was 30-40 Nodes. Question..... If you look at the History or Print out after one of these "Panel Drop Outs" , does it start with the same Node number? Also.... Here is what you Look at: 1-) Is 485 cards "seated" proper...

FireShield Configuration Utility (model number FSCU

Can anybody email me the Edwards fireShield Laptop Program?
and also.. Do I need a cable made up?

I am looking for software (and maybe programming manual of some sort) For the following panel: FCI 7100 series panel -- Needs Instruction Manual P/N 9000-0447 Ver-1.7 Also Has a Netsolo Broadband Voice Evac System (INCC Intelligent Network Command Centre) model designation--INI-VGC? Tried to change ...

3-LRMF is just a blank plate to cover open rail spot on the 3-chas7. I don't know where to find a cut sheet on this. They dont have an Installation sheet for the 3-LRMF because you have to be retarded not to be able to install it.